MENU

fluidized bed heat only boiler with 2.5 mw

We founded in 1988, with 32 years'experience in research development and manufacture of industrial boiler. Our boiler are saled for more than 100 countries and regions like Egypt, Ethiopia, Congo, Mauritius, Tanzania,South Africa, Mexico, Ireland, Indonesia etc.

  • Hold the ASME "S" and "U" Certificates and have earned ISO9001:2000 Certification.
  • High efficiency, low back pressure, ultra-low NOx emissions.
  • Elegant design with low surface temperature and low heat dissipation
  • Covers an area of 150 thousand square meters, with an annual production capacity of 2000 industrial boilers and 25000 tons of steam.

7*24 hours online service:zhulin@zozen.com

Get Free Quote

OUR PRODUCTS

Explore Recent Work

Fluidized Bed Furnace - an overview | ScienceDirect Topi

Fig. 10.8 shows a CFB boiler furnace. It differs from other biomass boiler types with regard to the solids separator, which is typically a cyclone (Kwauk and Li, 1999).The cyclone captures circulating bed material and unburned fuel particles and returns them to the lower part of the furnace through a loop seal (Lackermeier and Werther, 2002).After the cyclone, the flue gases flow through a

Heat Max Stainless Steel Fluidized Bed Boiler, HME Boile

We are offering wide range of Fluidized Bed Boiler to our valuable clients. These are available in different size and shape. These are made from high quality raw material. Our range of boiler offer are known for features like commercially clean internal and external heat transfer surfaces, durability.

3D CFD Simulation of Combustion in a 150 MWe Circulati

The gas-solid flow, heat /mass transfer and chemical reactions in Circulating Fluidized Bed (CFB) reactors are inherently coupled with spatio-temporal multi-scale structures, and featured with non-linear non-equilibrium behavior (1). For such a multi-phase complex system, it is inadequate to reproduce the real physical process

Utility Boiler Design/Cost Comparison: Fluidized-B

----- Table 56 ENVIRONMENTAL INTRUSION ADVANCED STEAM CYCLE-ATMOSPHERIC FLUIDIZED BED EMISSIONS S0x NO X HC CO ParticMlates LB/MBtu INPUT 1.028* 0.270** LB/kWh OUTPUT 0.0098 0.00253 0.040 0.099*** 0.00038 0.00094 THERMAL POLLUTION , :, Heat, Rejected Coaxing Towers, Btv/kWh Heat, Rejected Stack, Btu/kWh Heat, Rejected Total, Btu/kWh 4729 909

Progress of circulating fluidized bed combusti

The first lower energy consumption CFB boiler based on the re-specification of the fluidization state began commercial operational in 2007. As shown in Fig. 5, the field test results [] showed that with the pressure drop decrease from 7.3 to 3.2 kPa, the solid suspension density in the dilute zone was barely influenced due to the higher collection efficiency of the cyclones.

Circulating Fluidized Bed Boilers: Design, Operation a

This versatile resource explains how fluidized bed equipment works and how the basic principles of thermodynamics and fluid mechanics influence design, while providing insight into planning new projects, troubleshooting existing equipment, and appreciating the capabilities and limitations of the process.

(PDF) Heat Transfer in Fluidized Beds - ResearchGa

The circulating fluidized bed boiler (CFB boiler) is the second-generation fluidized bed boiler, the updated version of the bubbling fluidized bed boiler (BFB boiler).

CAPTURE OF SO2 BY LIMESTONE IN A 71 MWe PRESSURIZ

varied with load change to control the number of boiler tubes immersed in the dense bed, thus to control the heat recovery rate; the bed height was 3.5 and 2 m at the full load and 50% load, re specti vely. Total pre ssure was also var ied with load and it was 1 .1 and 0.7 MPa at the full load and 50% load, respectively. Temperature in the bed was

Circulating Fluidized Bed Boile

Cited by: 5 for reference only 2 5 6 8 7 Rated Steam Pressure (MPa) 1.25 1.6 2.5 3.82 5.3 Nominal steam temperature /oC Saturation 250 Saturation 350 Saturation 400 450 485 Rated Steam Capacity [t/h] 6 10 15 20 25 35 40 45 55 65 75 130 220 6 | Circulating Fluidized Bed Boilers CFB Steam Boiler Product Range Offerings Other capacities and pressures can be

Effect of Furnace Pressure Drop on Heat Transfer in a 1

The effects of furnace pressure drop on heat transfer in a 135 MW CFB boiler were also modeled by Liu et al. [16]. The results showed that when the total pressure drop decreased by 1 kPa from the

FURNACE DESIGN OF 210 MW CIRCULATING FLUIDIZED BED

power, 40% are related to only 210 MW pulverized coal (PC) fired plants with number of units [22]. But, it is proved that CFB technology is preferable for present environmental conditions 2.5. Furnace cross section Furnace Design of 210 MW Circulating Fluidized Bed Boiler-Numerical Investigation . …

What Can I Do For You?

Send us your inquiry
Leave Us Message

You can send a message to us by this email to zhulin@zozen.com

If you have any problems about our product and service,please feel free to give your inquiry in the form below. We will reply you within 24 hours as soon as possible.Thank you!

  • Boiler type
  • Name
  • email
  • Phone or Whatsapp
  • message
I accept the Data Protection Declaration
Are You Looking for A Consultant? ONLINE SERVICE
totop