MENU

1.5 ml kl hr capacities thermic fluid heater

We founded in 1988, with 32 years'experience in research development and manufacture of industrial boiler. Our boiler are saled for more than 100 countries and regions like Egypt, Ethiopia, Congo, Mauritius, Tanzania,South Africa, Mexico, Ireland, Indonesia etc.

  • Hold the ASME "S" and "U" Certificates and have earned ISO9001:2000 Certification.
  • High efficiency, low back pressure, ultra-low NOx emissions.
  • Elegant design with low surface temperature and low heat dissipation
  • Covers an area of 150 thousand square meters, with an annual production capacity of 2000 industrial boilers and 25000 tons of steam.

7*24 hours online service:zhulin@zozen.com

Get Free Quote

OUR PRODUCTS

Explore Recent Work

Industrial Circulation Heaters | Electric Inline Heate

Circulation heaters are powerful, electric in-line heaters constructed of a screw plug or flange-mounted tubular heater assembly installed into a mating tank or vessel. Non-pressurized or highly pressurized fluids can be heated very effectively using direct circulation heating.

Thermic Fluid Heater - Thermic Fluid Heaters Manufactur

“THERMOTECH” : Thermic fluid heater’s are available in Horizontal & vertical models where in thermic fluid can be heated up to normal 340 o C at near atmospheric pressure with efficiency as high as 92% on GCV of Oil and Gas fuel.. The Main Heat Exchanger is designed with an integrated combustion chamber made out of High Heat Resistant Steel Tubes : BS 3059 P-1 or Seamless Pipes : SA106

OWTHERM Heat Transfer Fluid Q - Dow Chemical Compa

the heater and/or energy recovery unit, preventing chemical contami-nation, and eliminating contact of the fluid with air. Chemical Contamination A primary concern regarding chemical contaminants in a heat transfer fluid system is their relatively poor thermal stability at elevated temperatures. The thermal degradation of chemical

Thermolec | Thermo-A

The THERMO-AIR heater is a quality product engineered for peak performance, low operating cost and long life. Features. NEW EXPANDED RANGE; CAPACITIES FROM 1 to 12 KW; FITS FROM 5" TO 12" DIAMETER DUCTS; BUILT-IN ADJUSTABLE ELECTRONIC DUCT SENSOR 0°C to 42°C (32°F to 108°F) JUST ONE ELECTRICAL CONNECTION AND THE UNIT IS READY TO PERFORM

ELITE Thermic Fluid Heaters - 2.imimg.c

Thermic Fluid Heaters The fuel pre-heater is thermic fluid cum electric type, so the connected electrical load mentioned for fuel pre-heater is applicable 1.5 3 5 7.5 1.12 2.24 3.73 5.59 1440 1 1 2 Driven by combustion air blower motor only 0.75 1.49 3 4.5 6 6 9 9 15

Thermal Fluid Heate

Sizes from 75,000 to 40,000,000 BTU/HR Thermal Fluid Heaters. Fluid Heater Press, Mold, or Platten Bath or Kettle Rolls FryerR eactorO ven *Saturated steam or pressurized water Heater Inlet/Outlet Connections IN 1.25 1.5 2 2.5 3 3 4 4 6 6 6 MM 32 38 51 64 76.3 76 102 102 152 152 152

Thermal Fluid Heaters - Hunt Boile

thermal fluid system is governed by the process requirements. The range or process temperature is a deciding factor. If the system’s required temperature is above the freezing point of water (0°C) and below approximately 177°C, the choice is usually steam. However, if the required temperature is below 0°C or above 177°C, thermal fluid may

Thermic Fluid Heaters - Thermic Fluid Boiler Latest Pri

Coil Type: 50, 000 to 5, 000, 000 kcal/hr.. Efficiency: Overall efficiency of 88 % (+/-2%) on NCV. Fuels: LDO, HSD, FO, LSHS, Natural gas, LPG, Biogas.. Temperature: Range 300 deg C for standerd unit and 350 & 400 deg C for high temprature. We are recognized among the major Oil and Gas Fired

Heater Specs Detailed - Thermal Oil & Fluid Heate

1.5 Heater Control Cabinet: A local control cabinet shall be furnished and mounted on the heater and contains the following: 1.5.1 Heater Main "On-Off" Switch. 1.5.2 Flame Safety Reset Switch. 1.5.3 Four (4) Operating Mode Lights: A. Power On. B. Burner On. C. Call For Heat. D. Alarm. 1.5…

Hot oil heaters and thermal fluids: the complete gui

The system diagram shown in figure 2, (in which the entire assembly contains a heat transfer fluid (3), a heating element – an electric element (1), and one of the boundary walls of this fluid is also a heat exchange surface with the heat consumer (2)), should be considered as a heat exchange system without an intermediate system or circuit

Thermic Fluid Heaters in Ahmedabad, थर्मिक फ्लूइड हीट

Business listings of Thermic Fluid Heaters, Thermic Fluid Boiler manufacturers, suppliers and exporters in Ahmedabad, थर्मिक फ्लूइड हीटर विक्रेता, अहमदाबाद, Gujarat along with their contact details & address. Find here Thermic Fluid Heaters, Thermic Fluid Boiler suppliers, manufacturers, wholesalers, traders with Thermic Fluid

What Can I Do For You?

Send us your inquiry
Leave Us Message

You can send a message to us by this email to zhulin@zozen.com

If you have any problems about our product and service,please feel free to give your inquiry in the form below. We will reply you within 24 hours as soon as possible.Thank you!

  • Boiler type
  • Name
  • email
  • Phone or Whatsapp
  • message
I accept the Data Protection Declaration
Are You Looking for A Consultant? ONLINE SERVICE
totop